Dell EMC PowerEdge R540 - Installing Expansion Card on the System Board

Figure 78. Installing the ller bracket
NOTE
: Filler brackets must be installed over empty expansion card slots to maintain FCC certication of the system. The
brackets also keep dust and dirt out of the system and aid in proper cooling and airow inside the system.
Next step
1 Install the expansion card on the system board
Installing expansion card on the system board
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2 If you are installing a new card, remove the ller bracket.
a Pull and lift up the expansion card retention latch lock to open.
b Pull the ller bracket upward out of the system.
Installing and removing system components
125