Dell EMC PowerEdge R540 - M.2 SSD Module; Removing the M.2 SSD Module

Next steps
1 Follow the procedure listed in After working inside your system.
2 Install any device drivers required for the card as described in the documentation for the card.
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 If installed, remove the rear drive cage.
5 Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1 Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card.
2 Lift the M.2 SSD module and slide it out of the connector on the BOSS card.
Figure 89. Removing the M.2 SSD module
Next step
Replace the M.2 SSD module.
Installing and removing system components
133