Dell EMC PowerEdge R540 - Installing the System Board

Figure 126. Removing the system board
Next step
Installing the system board.
Installing the system board
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Unpack the new system board assembly.
CAUTION
: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identication button while placing the system board into the chassis.
2 Holding the system board holder, push the system board toward the back of the system till it is seated.
3 Using Phillips #2 screwdriver, tighten the screws to secure the system board to the chassis.
172
Installing and removing system components