Steps
1 Using Phillips #2 screwdriver, remove the screws that secure the drive backplane to the rear drive cage.
2 Disengage the backplane from the hooks on the rear drive cage, and remove it from the rear drive cage.
Figure 101. Removing 3.5-inch rear drive backplane
Next step
Install the 3.5-inch rear drive backplane.
Installing the 3.5-inch rear drive backplane
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Use the hooks on the rear drive cage as guides to align the drive backplane.
2 Lower the backplane into the system until it is rmly seated.
3 Using Phillips #2 screwdriver, replace the screws to secure the backplane to the rear drive cage.
144
Installing and removing system components
To Next Page
Loading...
