Figure 123. Removing right control panel
3 Holding by the sides, remove the right control panel assembly away from the system.
Next step
Installing the right control panel
Installing the right control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable through the side wall of the system.
2 Align the right control panel assembly with the control panel slot on the system and attach the control panel assembly to the system.
3 Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
4 Using a Phillips #1 screwdriver, tighten the screws to secure the right control panel assembly to the system.
Installing and removing system components
169
To Next Page
Loading...
