Dell EMC PowerEdge R540 - Page 60

System Security
You can use the System Security screen to perform specic functions such as setting the system password, setup password and disabling
the power button.
Viewing System Security
To view the System Security screen, perform the following steps:
1 Power on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to nish booting, and then restart
your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click System Security.
System Security Settings details
The System Security Settings screen details are explained as follows:
Option
Description
Intel(R) AES-NI Improves the speed of applications by performing encryption and decryption by using the Advanced Encryption
Standard Instruction Set (AES-NI). This option is set to Enabled by default.
System Password Enables you to set the system password. This option is set to Enabled by default and is read-only if the password
jumper is not installed in the system.
Setup Password Enables you to set the system setup password. This option is read-only if the password jumper is not installed in
the system.
Password Status Enables you to lock the system password. This option is set to Unlocked by default.
TPM Security
NOTE: The TPM menu is available only when the TPM module is installed.
Enables you to control the reporting mode of the TPM. The TPM Security option is set to O by default. You can
only modify the TPM Status TPM Activation, and the Intel TXT elds if the TPM Status eld is set to either On
with Pre-boot Measurements or On without Pre-boot Measurements.
When TPM 1.2 is installed, the TPM Security option is set to O, On with Pre-boot Measurements, or On
without Pre-boot Measurements.
Table 41. TPM 1.2 security information
Option Description
TPM Information Changes the operational state of the TPM. This option
is set to No Change by default.
TPM Firmware Indicates the rmware version of the TPM.
TPM Status Species the TPM status.
TPM Command Controls the Trusted Platform Module (TPM). When
set to None, no command is sent to the TPM. When
set to Activate, the TPM is enabled and activated.
60 Pre-operating system management applications