Figure 81. Removing expansion card riser 2A
2 To remove expansion card riser 2B or 2C, hold the riser by its edges and lift the riser from the riser connector on the system board.
Figure 82. Removing expansion card riser 2
Next step
Install the expansion card riser 2.
Installing expansion card riser 2
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 To install expansion card riser 2A:
a Align the screw and tab on the riser with the screw hole and slot on the system.
132
Installing and removing system components
To Next Page
Loading...
