Figure 104. Installing the network daughter card
Next steps
1 If applicable, install the expansion card riser 2.
2 Follow the procedure listed in After working inside your system.
Integrated storage controller card
Removing integrated storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the expansion card riser 1.
Steps
1 Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the system board.
2 Lift the integrated storage controller cable away from the integrated storage controller.
Installing and removing system components
151
To Next Page
Loading...
