Dell EMC PowerEdge R740 - Optional Internal USB Memory Key

Steps
1 Route the power and the USB cables on the USB 3.0 module through the USB 3.0 module slot on the front panel.
2 Insert the USB 3.0 module into the slot on the front panel.
3 Align the screws on the module with the screw holes on the system.
4 Using the Phillips #2 screwdriver, tighten the screw to secure the module to the system.
5 Route and connect the USB cable to internal USB port and power cable to the backplane 3 power connector on the system board.
To locate the connector, see the System board jumpers and connectors section.
Figure 124. Installing USB 3.0 module
Next steps
1 Install the internal USB memory key.
2 Install the air shroud.
3 Install the cooling fan assembly.
4 Install the backplane cover.
5 Follow the procedure listed in After working inside your system.
Optional internal USB memory key
Optional internal USB memory key details
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE
: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
For congurations that support USB 3.0 module, the USB 3.0 module cable connects to the internal USB port on the system board. In this
scenario, the default internal USB port is available under the backplane cover. The position of the default internal USB port may vary
depending on the conguration of your system.
166
Installing and removing system components