Figure 135. Installing left control panel
Next steps
1 Install the air shroud.
2 Install the cooling fan assembly.
3 Follow the procedure listed in After working inside your system.
Removing the right control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the cooling fan assembly.
Steps
1 Disconnect the VGA cable from the system board.
2 Pull the cable latch and disconnect the control panel cable from the system board connector.
3 Using Phillips #1 screwdriver, remove the screws that secure the control panel and cable tube to the system.
4 Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
Installing and removing system components
183
To Next Page
Loading...
