Dell EMC PowerEdge R740 - System Battery Specifications

PSU Class Heat dissipation
(maximum)
Frequency Voltage High line
200v240 V
Low line
100– 140 V
DC Current
China and
Japan only)
1600 W AC Platinum 6000 BTU/hr 50/60 Hz 100–240 V AC,
autoranging
1600 W 800 W
10 A
2000 W AC Platinum 7500 BTU/hr 50/60 Hz 100–240 V AC,
autoranging
2000 W 1000 W
11.5 A
2400 W AC Platinum 9000 BTU/hr 50/60 Hz 100–240 V AC,
autoranging
2400 W 1400 W
16 A
NOTE: Heat dissipation is calculated using the PSU wattage rating.
NOTE: This system is also designed to connect to the IT power systems with a phase to phase voltage not exceeding 240 V.
NOTE: PSUs rated for 1100 W Mixed Mode HVDC or 1100 W AC and higher require high-line voltage (200–240 V AC) to supply
their rated capacity.
System battery specications
The PowerEdge R740 system supports CR 2032 3.0-V lithium coin cell system battery.
Expansion bus specications
The PowerEdge R740 system supports up to eight PCI express (PCIe) generation 3 expansion cards that can be installed on the system
board using expansion card risers. The following table provides detailed information about the expansion card riser specications:
Table 20. Expansion card riser
congurations
Expansion card
riser
PCIe slots on the
riser
Height Length Link
Riser 1A Slot 1 Full Height Full Length x16
Slot 3 Full Height Half Length x16
Riser 1B Slot 1 Full Height Full Length x8
Slot 2 Full Height Full Length x8
Slot 3 Full Height Half Length x8
Riser 1D Slot 1 Full Height Full Length x16
Slot 2 Full Height Full Length x8
Slot 3 Full Height Half Length x8
Riser 2A Slot 4 Full Height Full Length x16
Slot 5 Full Height Full Length x8
Slot 6 Low Prole Half Length x8
Riser 2B Slot 4 Low Prole Half Length x8
Riser 2C Slot 4 Low Prole Half Length x16
Riser 3A Slot 7 Full Height Full Length x8
34 Technical specications