Figure 111. Back view of 8 x 3.5 inch drive backplane
1 SAS connector (BP SAS B) 2 signal connector (J_BP_SIG)
3 SAS connector (BP SAS A) 4 power connector (J_BP_PWR_A)
Removing the backplane
The procedure to remove the backplane is identical for all backplane congurations.
Prerequisites
CAUTION
: To prevent damage to the drives and backplane, remove the drives from the system before removing the backplane.
CAUTION: Note the number of each drive and temporarily label them before you remove the drive so that you can replace them
in the same locations.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the cooling fan assembly.
5 Remove the backplane cover.
6 Remove all drives.
7 Disconnect all the cables from the backplane.
Step
Press the release tabs and lift the backplane to disengage the backplane from the hooks on the system.
Installing and removing system components
155
To Next Page
Loading...
