Next steps
1 Connect all the cables to the backplane.
2 Install all the drives.
3 Install the backplane cover.
4 Install the cooling fan assembly.
5 Install the air shroud.
6 Follow the procedure listed in After working inside your system.
Cable routing
Figure 114. Cable routing – 8 x 2.5 inch drive backplane with mini PERC
1
backplane 2 backplane power cable (BP: BP1 to MB: BP1 )
3 backplane signal cable (BP: BPSIG1 to MB: BPSIG1) 4 system board
5 mini PERC 6 SAS cable (BP: BP SAS A, BP SAS B to adapter PERC)
Installing and removing system components 157
To Next Page
Loading...
