Figure 46. Removing a drive blank
Next step
1 Install a drive or a drive blank
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION
: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 47. Installing a drive blank
Next step
If removed, install the front bezel.
Removing a drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If applicable, remove the front bezel.
Installing and removing system components
93
To Next Page
Loading...
