Figure 136. Removing right control panel
Next step
Install the right control panel.
Installing the right control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable and VGA cable through the side wall of the system.
2 Align the control panel with the control panel slot on the system and attach the control panel to the system.
3 Connect the VGA cable to the system board.
4 Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
5 Using a Phillips #1 screwdriver, install the screw that secures the control panel and cable tube to the system.
184
Installing and removing system components
To Next Page
Loading...
