Option Description
Table 44. UEFI iSCSI Settings screen details (continued)
Option Description
Connection 2 Enables or disables the iSCSI device. When disabled,
a UEFI boot option is created for the iSCSI device
automatically. This is set to Disabled by default.
Connection 1 Settings Enables you to control the configuration of the iSCSI
device.
Connection 2 Settings Enables you to control the configuration of the iSCSI
device.
Connection order
TLS
Authentication
Configuration
View and/or modify this device's boot TLS authentication mode. None means the HTTP server and the client will
not authenticate each other for this boot. One way means the HTTP server will be authenticated by the client,
while the client will not be authenticated by the server. This option is set to None by default.
Integrated Devices
You can use the Integrated Devices screen to view and configure the settings of all integrated devices including the video controller,
integrated RAID controller, and the USB ports.
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Integrated Devices.
Integrated Devices details
About this task
The Integrated Devices screen details are explained as follows:
Option
Description
User Accessible
USB Ports
Configures the user accessible USB ports. Selecting Only Back Ports On disables the front USB ports; selecting
All Ports Off disables all front and back USB ports; selecting All Ports Off (Dynamic) disables all front and
back USB ports during POST and front ports can be enabled or disabled dynamically by an authorized user or
authorized users without resetting the system.
The USB keyboard and mouse function in certain USB ports during the boot process, depending on the selection.
After the boot process is complete, the USB ports will be enabled or disabled as per the setting.
Internal USB Port Enables or disables the internal USB port. This option is set to On or Off. This option is set to On by default.
NOTE: The Internal SD Card Port on the PCIe riser is controlled by Internal USB Port.
56 Pre-operating system management applications
To Next Page
Loading...
