Figure 51. Removing a backplane
Next step
Install a hard drive backplane.
Installing a hard drive backplane
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the front bezel.
4 Remove the air shroud.
Steps
1 Use the hooks at the base of the system as guides to align the hard drive backplane.
2 Lower the hard-drive backplane into the system till the release pin locks in place, securing the hard drive backplane to the system.
3 Connect the data, signal, and power cables to the backplane.
100
Installing and removing system components
To Next Page
Loading...
