Figure 82. Installing a cabled PSU
Next step
Follow the procedure listed in After working inside your system.
Power interposer board
Removing the power interposer board
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
CAUTION
: To prevent damage to the power interposer board, you must remove the power supply units (PSUs) or PSU
blank from the system before removing the power interposer board (PIB).
3 Remove the PSUs or PSU blanks from the back of the chassis.
4 Remove the air shroud.
Steps
1 Disconnect the power cables from the drive backplane and the system board.
NOTE
: If installed, remove the expansion card to enable removing the P3 power cable from the system board.
2 Using the Phillips #2 screwdriver, remove the screw that secures PIB to the chassis.
3 Pressing the release latch on the PIB, lift the PIB to release it from the hooks on the PSU cage.
4 Lift the PIB out of the chassis.
Figure 83. Removing the power interposer board
Installing and removing system components
133
To Next Page
Loading...
