Figure 67. Installing the M.2 SSD module
Next steps
1 Install the BOSS card.
NOTE
: The procedure to install the BOSS card is similar to the removing an expansion card.
2 Install the applicable air shroud.
3 Follow the procedure listed in After working inside your system.
Optional IDSDM or vFlash module
Removing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system .
Steps
1 Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
2 Hold the MicroSD card and remove it from the slot.
NOTE
: Temporarily label each MicroSD card with its corresponding slot number after removal.
Next steps
1 Follow the procedure listed in After working inside your system.
2 Install a MicroSD card.
118
Installing and removing system components
To Next Page
Loading...
