Dell EMC PowerEdge T440 - Installing the Expansion Card Holder

2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
Step
Press the tab and remove the expansion-card holder from the chassis.
Figure 60. Removing the expansion card holder
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
Installing the expansion card holder
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Step
Align the expansion card holder with the projections on the chassis and push it down until rmly seated.
112
Installing and removing system components