Figure 41. Installing the optical drive cage or tape drive
Next steps
1 Follow the procedure listed in After working inside your system.
2 If applicable, install the bezel.
Cabled drives
CAUTION
: Do not turn o or restart your system while the drive is being formatted. Doing so can cause a drive failure.
Removing the internal hard drive bay
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Disconnect the data and power cable(s) from the hard drive(s).
Steps
1 Loosen the two captive screws securing the internal hard drive bay to the chassis.
2 Lift the internal hard drive bay up and out of the chassis.
Installing and removing system components
89
To Next Page
Loading...
