Dell EMC PowerEdge T440 - Drive Indicator Codes

Table 6. System health and system ID indicator codes
System health and system ID indicator
code
Condition
Solid blue Indicates that the system is turned on, system is healthy, and system ID mode is not active.
Press the system health and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID button
to switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem persists, see Getting help.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log for specic
error messages. For information about the event and error messages generated by the
system rmware and agents that monitor system components, see the Error Code Lookup
page at qrl.dell.com
Drive indicator codes
Each drive carrier has an activity LED indicator and a status LED indicator. The indicators provide information about the status of the drive.
The activity LED indicator indicates whether the drive is in use or not. The status LED indicator indicates the power condition of the drive.
Figure 8. Drive indicators
1
Drive activity LED indicator 2 Drive status LED indicator
3 Drive capacity label
NOTE: If the drive is in the Advanced Host Controller Interface (AHCI) mode, the status LED indicator does not turn on.
Table 7. Drive indicator codes
Drive status indicator code Condition
Flashes green twice per second Identifying drive or preparing for removal.
O Drive ready for removal.
18 Dell EMC PowerEdge T440 system overview