Figure 59. Installing the external cooling fan
Next steps
1 Install the air shroud.
2 Follow the safety guidelines listed in After working inside your system.
Optional internal USB memory key
Replacing the optional internal USB memory key
Prerequisites
CAUTION
: To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Locate the USB port or USB memory key on the system board.
To locate the USB port, see Jumpers and connectors.
2 If installed, remove the USB memory key from the USB port.
3 Insert the replacement USB memory key into the USB port.
Next steps
1 Follow the procedure listed in After working inside your system.
2 While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Expansion card holder
Removing the expansion card holder
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
Installing and removing system components
111
To Next Page
Loading...
