Figure 33. Installing a drive into the drive carrier
Removing a 2.5-inch drive from a 3.5-inch drive adapter
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Remove the 3.5-inch drive adapter from the 3.5-inch hot swappable drive carrier.
NOTE
: A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier.
Steps
1 Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
2 Remove the 2.5-inch drive from the 3.5-inch drive adapter.
Installing and removing system components
81
To Next Page
Loading...
