Figure 76. Installing a processor and heat sink module
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
Power supply units
NOTE
: For more information, see the Technical specications section.
CAUTION: If two PSUs are installed, both the PSUs must have the same type of label. For example, Extended Power
Performance (EPP) label. Mixing PSUs from previous generations of PowerEdge servers is not supported, even if the PSUs have
the same power rating. Mixing PSUs will result in mismatch condition or failure to turn the system on.
128 Installing and removing system components
To Next Page
Loading...
