Dell EMC PowerEdge T440 - Optional Front Bezel; Removing the Front Bezel; Installing the Front Bezel

The key is required only if your system includes a bezel.
• Phillips #1 screwdriver
• Phillips #2 screwdriver
• Torx #T30 screwdriver
• Wrist grounding strap
Optional front bezel
Removing the front bezel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Unlock the bezel by using the bezel key.
NOTE: There are two bezel keys attached to the back of the bezel.
2 Press the release latch at the top of the bezel.
3 Pull the top end of the bezel away from the system.
4 Unhook the bezel tabs from the slots at the bottom of the system, and pull the bezel away from the system.
Figure 16. Removing the front bezel
Installing the front bezel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Locate and remove the bezel key.
Installing and removing system components
65