Figure 18. Removing the system feet
Next step
If applicable, install the system feet or the caster wheel assembly.
Installing the system feet
Prerequisites
CAUTION
: Install the feet on a stand-alone tower system to provide stability to the system. An unstable system might tip over
and cause injury to the user or damage to the system.
1 Follow the safety guidelines listed in Safety instructions.
2 Place the system on its side, on a at, stable surface.
Steps
1 Align the three tabs on the system foot with the three slots on the base of the system.
2 Using the Phillips #2 screwdriver, secure the screw that secures the foot to the base of the system.
a Repeat the above steps to install the remaining system feet.
Installing and removing system components
67
To Next Page
Loading...
