Dell EMC PowerEdge T440 - Removing the Processor from the Processor and Heat Sink Module

3 Set the PHM aside with the processor side facing up.
Figure 70. Removing the processor and heat sink module
Next step
Install the processor and heat sink module.
Removing the processor from the processor and heat sink
module
Prerequisites
NOTE
: Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
122
Installing and removing system components