Figure 92. Installing the system board
4 Using the Phillips #2 screwdriver secure the system board to the chassis with screws.
Next steps
1 Replace the following:
a Trusted Platform Module (TPM)
b Memory modules
c Processors and heat sink modules
d Internal USB key
e vFlash/IDSDM module
f Integrated storage controller card
g Expansion cards, if installed
h Expansion card holder
i GPU card holder
j Air shroud
2 Reconnect all cables to the system board.
NOTE
: Ensure that the cables inside the system are routed along the chassis wall and secured by using the cable
securing bracket.
3 Follow the procedure listed in After working inside your system.
4 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the Restoring the Service Tag using Easy
Restore section.
b If the Service Tag is not backed up in the backup ash device, enter the Service Tag manually. For more information, see the
Restoring the Service Tag using Easy Restore section.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Upgrading the Trusted Platform Module section.
5 Import your new or existing iDRAC Enterprise license.
For more information, see iDRAC User's Guide, at www.dell.com/poweredgemanuals
Installing and removing system components
141
To Next Page
Loading...
