28 Preparing Your Multi-Function Printer
7
If your printer doesn’t respond, or if the IP address is not what you expected:
a
Insert the
drivers and utilities CD
into your computer.
If setup does not start automatically:
• Launch the
drivers and utilities CD
: click
Start
→
Run
and browse your CD drive (for example,
type D:\ where D is the drive letter of your CD).
• Select S
ETUP.EXE
, and then click
OK
.
b
When the drivers and utilities CD screen appears, click
SetIP Address Utility
.
c
Select your printer from the Configure Print Servers list.
d
Make the necessary changes, and then click
Config
.
e
Exit the program.
f
Print and check the Network Configuration page to verify your changes.
Run the Installation Software
1
Insert the
drivers and utilities CD
into your computer.
2
When the
drivers and utilities CD
screen appears, select
Network Installation
and click
Next
.
3
For local installation, select
Local Installation
and click
Next
.
For remote installation:
• Select
Remote Installation
.
• Enter your Administrator user name and password, and then click
OK
.
• Manually enter or browse for the clients or servers and click
Add
.
• When you are finished adding remote computers, click
Next
.
4
Select the network printer you want to install. If you do not see your printer listed, click
Update
to
refresh the list or click
Add Printer
to add a printer to the network.
5
If you are setting up the printer on a server that will provide printing services for client computers,
select
I am setting up this printer on a server
.
6
Click
Next
.
7
Select any additional software or documentation components you want to install, and then click
Next
.
8
To change any of the listed printer names, select the printer from the list. Enter a new name in the
Printer name
field and click
Apply
.
9
If you want other users on the network to access this printer, select
Share this printer with other
computers
, and then enter a share name that users will easily identify.
10
Click
Next
.
11
When the Congratulations! screen appears, you printer software is installed. Click
Finish
to close the
installation window.
To Next Page
Loading...
