CAUTION: If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure
that thermal conductivity is achieved.
Steps
1. Place the heat-sink assembly on the system board.
2. Align the screw holes on the heat-sink assembly with the screw holes on the system board.
3. Replace the six screws (M2x4) that secure the heat-sink assembly to the system board.
4. Turn the system board over, and connect the left and right fan cables.
Next steps
1. Follow the procedure from step 4 to step 20 in Installing the system board.
2. Install the rear I/O-cover.
3. Install the battery.
4. Install the
wireless card.
5. Install the memory module.
6. Install the I/O board.
7. Install the 2230 solid-state drive or 2280 solid-state drive in SSD slot one, whichever applicable.
8. Install the 2230 solid-state drive or 2280 solid-state drive in SSD slot two, whichever applicable.
9. Install the base cover.
67
To Next Page
Loading...
