EasyManuals Logo

Dell Alienware m15 R6 User Manual

Dell Alienware m15 R6
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
Use the following guidelines to assign the system password:
A password can have up to 32 characters.
The password can contain the numbers 0 through 9.
Only lower case letters are valid, upper case letters are not allowed.
Only the following special characters are allowed: space, (”), (+), (,), (-), (.), (/), (;), ([), (\), (]), (`).
3. Type the system password that you entered earlier in the Confirm new password field and click OK.
4. Press Esc and a message prompts you to save the changes.
5. Press Y to save the changes.
The computer reboots.
Deleting or changing an existing system setup password
Prerequisites
Ensure that the Password Status is Unlocked (in the System Setup) before attempting to delete or change the existing System and
Setup password. You cannot delete or change an existing System or Setup password, if the Password Status is Locked.
About this task
To enter the System Setup, press F2 immediately after a power-on or reboot.
Steps
1. In the System BIOS or System Setup screen, select System Security and press Enter.
The System Security screen is displayed.
2. In the System Security screen, verify that Password Status is Unlocked.
3. Select System Password, alter or delete the existing system password and press Enter or Tab.
4. Select Setup Password, alter or delete the existing setup password and press Enter or Tab.
NOTE: If you change the System and/or Setup password, re enter the new password when prompted. If you delete the
System and Setup password, confirm the deletion when prompted.
5. Press Esc and a message prompts you to save the changes.
6. Press Y to save the changes and exit from System Setup.
The computer restarts.
Clearing CMOS settings
About this task
CAUTION: Clearing CMOS settings will reset the BIOS settings on your computer.
Steps
1. Remove the base cover.
2. Disconnect the battery cable from the system board.
3. Press the power button for 20 seconds.
4. Wait for one minute.
5. Connect the battery cable to the system board.
6. Install the
base cover.
Clearing BIOS (System Setup) and System passwords
About this task
To clear the system or BIOS passwords, contact Dell technical support as described at www.dell.com/contactdell.
87

Table of Contents

Other manuals for Dell Alienware m15 R6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell Alienware m15 R6 and is the answer not in the manual?

Dell Alienware m15 R6 Specifications

General IconGeneral
Processor11th Gen Intel Core i7-11800H or i9-11900H
GraphicsNVIDIA GeForce RTX 3060
Display15.6-inch FHD (1920 x 1080) 165Hz
RAM32GB DDR4 3200MHz
StorageUp to 2TB PCIe NVMe SSD
Operating SystemWindows 10 Home
Battery86Wh
WeightStarting at 2.69 kg (5.93 lbs)
Ports1x HDMI 2.1
WirelessKiller Wi-Fi 6 AX1650

Related product manuals