Power button
Removing the power button
Prerequisites
1. Follow the procedure in
Before working inside your computer.
2. Remove the base cover.
3. Remove the 2230 solid-state drive or 2280 solid-state drive in SSD slot one, whichever applicable.
4. Remove the 2230 solid-state drive or 2280 solid-state drive in SSD slot two, whichever applicable.
5. Remove the
I/O board.
6. Remove the memory module.
7. Remove the wireless card.
8. Remove the display assembly.
9. Remove the battery.
10.Remove the
rear I/O-cover.
11. Follow the procedure from step 1 to step 16 in Removing the system board.
NOTE: System board can be removed with the heat-sink assembly and USB board attached.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Steps
1. Remove the three screws (M2x2) that secure the power-button bracket to the palm-rest and keyboard assembly.
2. Lift the power-button bracket off the palm-rest and keyboard assembly.
3. Peel and lift the power button off the palm-rest and keyboard assembly.
70
To Next Page
Loading...
