Steps
1. Place the top heat-sink on the system board.
2. Align the screw holes on the top heat-sink to the screw holes on the system board.
3. Replace the four screws (M2x3) that secure the top heat-sink to the system board.
Next steps
1. Install the
rear I/O cover.
2. Install the base cover.
3. Follow the procedure in
After working inside your computer.
Power-adapter port
Removing the power-adapter port
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the
base cover.
3. Remove the rear I/O cover.
4. Remove the top heat-sink.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal procedure.
66
To Next Page
Loading...
