Steps
1. Turn over the system-board assembly.
2. In reverse sequential order (8>7>6>5>4>3>2>1), loosen the eight captive screws (M2) that secure the fan and heat-sink
assembly to the system board.
3. Lift the heat-sink assembly off the system board.
Installing the heat-sink assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the installation
procedure.
83
To Next Page
Loading...
