Dell C1765NFW - Page 181

Understanding the Printer Menus 179
Reset Wireless (Dell C1765nfw Color Multifunction Printer only)
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network
settings are reset to their default values.
NOTE: This item is displayed when the Ethernet cable is disconnected and Wi-Fi is set to On.
TCP/IP
Purpose:
To configure TCP/IP settings. The change takes effect after the printer is turned off and then on.
Va lu es :
Protocol
Purpose:
To enable or disable each protocol. The change takes effect after the printer is turned off and then on.
Va lu es :
No* Does not reset the wireless setting.
Yes Resets the wireless setting.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv4 Get IP Address AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator panel.
IP Address Manually sets the IP address allocated to the printer.
Subnet Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.
LPD Disable Disables the Line Printer Daemon (LPD) port.
Enable* Enables the LPD port.
Port9100 Disable Disables the Port9100 port.
Enable* Enables the Port9100 port.
WSD Disable Disables the Web Services on Devices (WSD) port.
Enable* Enables the WSD port.
SNMP Disable Disables the Simple Network Management Protocol (SNMP) UDP port.
Enable* Enables the SNMP UDP port.
E-Mail Alert Disable Disables the E-Mail Alert feature.
Enable* Enables the E-Mail Alert feature.