Table 7. System setup options—Advanced menu(continued)
Advanced
HyperThread Control
HyperThread Control Enables or disables HyperThread Control.
Default: Enabled
Multiple-Core Support
Multiple-Core Support Allows you to configure Multiple-Core support.
Default: All
Multiple Atom cores
Multiple Atom cores Allows you to configure Multiple Atom cores.
Default: All
Trusted Execution
Trusted Execution Allows you to enable or disable Trusted Execution.
Default: Enabled
Integrated NIC
Integrated NIC Allows you to enable or disable the integrated NIC.
Default: Enabled
SATA/NVME Operation
SATA/NVME Operation Sets the operating mode of the integrated storage device
controller.
Default: RAID on
PCIe Resizable Base Address Register
PCIe Resizable Base Address Register Allows you to enable or disable the Resizable Base Address
Register (BAR) feature.
Default: Disabled
IPv4 HTTP Support
IPv4 HTTP Support Allows you to enable or disable IPv4 HTTP Support.
Default: Disabled
IPv6 HTTP Support
IPv6 HTTP Support Allows you to enable or disable IPv6 HTTP Support.
Default: Disabled
USB Configuration
Front USB Ports Allows you to enable or disable the Front USB ports.
Default: Enabled
Rear USB Ports Allows you to enable or disable the Rear USB ports.
Default: Enabled
Power Options
AC Recovery Sets what action the computer takes when power is restored.
Default: Power Off
Deep Sleep Control Allows you to define the controls when Deep Sleep is enabled.
Default: Enabled in S4 and S5
100 System setup
To Next Page
Loading...
