Table 7. System setup options—Advanced menu(continued)
Advanced
USB Wake Support Allows you to enable the USB devices to wake the system
from Standby.
Default: Enabled
USB PowerShare in S4/S5 state Allows you to charge external devices.
Default: Disabled
USB PowerShare in Sleep State Allows you to enable front the USB devices to wake the
system from sleep state.
Default: Normal
Auto Power On Allows you to enable or disable Auto Power On.
Default: Disabled
Auto Power On Mode Allows you to set the computer to turn on automatically every
day or on a preselected date. This option can be configured
only if the Auto Power On mode is set to Enabled Everyday or
Selected Day.
Default: Selected Day
Auto Power On Date Allows you to set the date on which the computer must turn
on automatically. This option can be configured only if the Auto
Power On mode is set to Enabled 1 to 31.
Default: 15
Auto Power On Time Allows you to set the time at which the computer must turn
on automatically. This option can be configured only if the Auto
Power On mode is set to Enabled hh:mm:ss.
Default: 12:30:30
Numlock Key Allows you to set the status of the Num Lock key during boot
to On or Off.
Default: Enabled
Performance Options
Overclocking Feature Allows you to enable or disable the Overclocking Feature.
Default: Disabled
Overclocking Feature
Core Over Clocking Level# Allows you to configure the Core Over Clocking Level.
Default: Disabled
Customization
Core Ratio Limit Override Allows you to configure the Core Ratio Limit Override.
Core Voltage Override Allows you to configure the Core Voltage Override.
Long Duration PWR Limit Allows you to configure the Long Duration PWR Limit.
Short Duration PWR Limit Allows you to configure the Short Duration PWR Limit.
XMP Memory Allows you to configure the XMP Memory.
Default: Disabled
Maintenance
Data Wipe on next boot When enabled, the BIOS will schedule a data wipe cycle for
all storage devices that are connected to the system board on
the next reboot.
System setup 101
To Next Page
Loading...
