Dell EMC PowerStore 500T - Replacing a DIB

3. Press down firmly on the latches, and then pull the latches to remove the DIB from the chassis.
NOTE: The DIB comes completely out of the chassis. In addition to holding the latches, be prepared to support the DIB
to avoid dropping it.
A
B
1
1
2
2
Figure 124. Removing the DIB
Replacing a DIB
Steps
1. Align the DIB with the empty slot and carefully push it into the slot until the latches are engaged and start to rise.
A
B
1
1
2
2
Figure 125. Installing the DIB
2. Press up on the DIB latches to lock them into place.
108
NVMe expansion enclosure service procedures