Figure 27. Slide system into the rack
Installing cable management arms
About this task
To properly orient the cable management arms, hold them with the silver side facing down. The words "Upper" and "Lower" on
the arms should be legible.
Steps
1. Install the lower cable management arm:
a. On the right-hand side of the rear of the cabinet, align the two retention latches with the two lower rail clips, and insert
them into the clips until you feel and hear an audible click.
2. Install the upper cable management arm:
a. On the left-hand side of the rear of the cabinet, align the two retention latches with the two upper rail clips, and insert
them into the clips until you feel and hear an audible click.
Install a new base enclosure and optional expansion enclosure
31
To Next Page
Loading...
