Figure 36. Removing a drive filler module
Install a 2.5" drive
About this task
CAUTION:
If you are installing multiple drives in a system that is powered up, wait one to two minutes before
sliding the next drive into position.
Steps
1. Align the drive with the guides in the slot.
2. With the latch fully opened, gently push the drive into the slot.
The latch begins to rotate downward when it meets the enclosure.
3. Push the orange button until the drive is fully seated in the slot.
4. Push the latch down until it locks into place.
Base enclosure service procedures
41
To Next Page
Loading...
