3. Pull the bezel off the cabinet, and put it on a clean, static-free surface.
Figure 98. Removing the front bezel
Remove a faulted drive
Steps
1. Locate the drive with the blinking amber LED fault light.
2. Push down the orange button to release the latch.
3. Remove the drive from the slot.
Figure 99. Removing a drive
4. Place the drive on a static-free surface.
Installing a drive
About this task
NOTE:
If you are installing multiple drives in a system that is powered up, wait at least 10 seconds before sliding the next
drive into position.
NVMe expansion enclosure service procedures 85
To Next Page
Loading...
