Figure 52. Removing the embedded module cover
Remove a 4-port card
Steps
1. Remove the SFPs from the front of the embedded module.
2. Push down the two blue tabs on the back of the 4-port card to release the 4-port card.
Figure 53. Opening the retaining tabs
3. Lift the 4-port card off the pegs, and pull the 4-port card away from the embedded module.
NOTE:
If you are having difficulty removing the 4-port card, loosen the four captive screws that secure the air dam to
the front of the embedded module .
Base enclosure service procedures 53
To Next Page
Loading...
