EasyManuals Logo

Dell Force10 S50N Series User Manual

Dell Force10 S50N Series
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Site Preparations | 13
3
Site Preparations
This chapter describes requirements and procedures to install your system in the following topics:
Site Selection
Cabinet Placement on page 13
Rack Mounting on page 14
Fans and Airflow on page 14
Power on page 14
Storing Components on page 16
Tools Required on page 16
For detailed switch specifications, refer to
Chapter , Switch Specifications, on page 47
.
NOTE: Install the switch into a rack or cabinet before installing any optional components.
Site Selection
Make sure that the area where you install your switch meets the following safety requirements:
Near an adequate power source. Connect the system to the appropriate branch circuit protection as
defined by your local electrical codes. See cautions in Information Symbols and
Warnings on page 5.
Environmental temperature between 32° – 122°F (0° – 50°C).
Relative humidity that does not exceed 85% non-condensing.
In a dry, clean, well-ventilated and temperature-controlled room, away from heat sources such as hot air
vents or direct sunlight.
Away from sources of severe electromagnetic noise.
Positioned in a rack, cabinet, or on a desktop with adequate space in the front, rear, and sides of the unit
for proper ventilation, and access.
Cabinet Placement
The cabinet must meet the following criteria:
Minimum cabinet size and airflow are according to the EIA standard.
Minimum of 5 inches (12.7 cm) between the side intake and exhaust vents and the cabinet wall.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell Force10 S50N Series and is the answer not in the manual?

Dell Force10 S50N Series Specifications

General IconGeneral
Rack Units1U
Jumbo FramesUp to 9216 bytes
Product TypeSwitch
Form FactorFixed
Power SupplyDual redundant power supplies
VLAN SupportYes
Operating Temperature0°C to 40°C (32°F to 104°F)
Storage Temperature-40°F to 158°F (-40°C to 70°C)
ModelDell Force10 S50N Series

Related product manuals