Table 7. System setup options—Display menu(continued)
Display
Touch Screen Enables or disables the touch screen for the OS.
NOTE: The touch screen will always work in the BIOS setup irrespective
of this setting.
Full Screen Logo Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
Table 8. System setup options—Connection menu
Connection
Network Controller Configuration Enables or disables the network controller.
By default, Integrated NIC is selected.
Wireless Device Enable Enable or disable internal WLAN/Bluetooth devices.
By default, WLAN is selected.
By default, Bluetooth is selected.
Enable UEFI Network Stack
Enable UEFI Network Stack When enabled, UEFI networking protocols are installed and available, allowing pre-OS
and early OS networking features to use any enabled NICs. This may be used without
PXE turned on.
Default: ON
Wireless Radio Control
Control WLAN radio Enables to sense the connection of the computer to a wired network and
subsequently disable the selected wireless radios (WLAN and/or WWAN). Upon
disconnection from the wired network, the selected wireless radios are re-enabled.
Default: OFF
Table 9. System setup options—Power menu
Power
Battery Configuration Enables the computer to run on battery during power usage hours. Use the below
options to prevent AC power usage between certain times of each day.
By default Adaptive is selected.
Advanced Configuration
Enable Advanced Battery Charge
Configuration
Enables Advanced Battery Charge Configuration from the beginning of the day to a
specified work period. Advanced Battery Charged maximizes battery health while still
supporting heavy use during the work day.
Default: OFF
Peak Shift Enables the computer to run on battery during peak power usage hours.
Default: OFF
Thermal Management Sets cooling fan and processor heat management to adjust system performance,
noise, and temperature.
By default, Optimized is selected.
USB Wake Support
Wake on Dell USB-C Dock Enables connecting a Dell USB-C Dock to wake the computer from Standby.
Default: ON
System setup 81
To Next Page
Loading...
