a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the hard drive tray:
a. Peel the adhesive tape [1].
b. Lift the latch [2] and disconnect the hard drive cable from the connector [3].
c. Lift the latch [4] and disconnect the system board cable from the connector [5].
d. Remove the screws that secure the hard drive tray to the computer [6].
e. Lift the hard drive tray away from the computer [7].
Installing the hard drive tray
1. Place the hard drive tray on the computer.
2. Tighten the screws to secure the hard drive tray to the computer.
3. Connect the system board cable to the connector.
4. Connect the hard drive cable to the connector.
5. Fix the adhesive tape.
6. Install the:
a. base cover
b. optical drive
c. hard drive
d. battery
7. Follow the procedure in After working inside your computer.
23
To Next Page
Loading...
