c. GPS board
d. base cover
e. optical drive
f. hard drive
g. battery
6. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To release the display assembly:
a. Lift the latch [1] and disconnect the I/O cable from the connector on the system board [2].
b. Remove the screws that secure the metal tab [3].
c. Lift the metal tab to access the eDP cable [4].
d. Disconnect the eDP cable on the system board [4].
4. Peel the adhesive tape [1] [3] and disconnect the display cables from the connectors [2] [4].
36
To Next Page
Loading...
