a. display assembly
b. base cover
c. optical drive
d. hard drive
e. battery
8. Follow the procedure in After working inside your computer.
Input/Output(I/O) board
Removing the I/O board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To access the I/O board:
a. Release the latch door and remove the screws [1].
b. Peel the adhesive tape [2].
4. To release the I/O board:
a. Peel the adhesive tape [1].
b. Lift the latch [1] and disconnect the I/O board cable from the connector [2].
c. Peel the adhesive tape [4] and disconnect the display cable [5].
40
To Next Page
Loading...
