5. Install the:
a. base cover
b. optical drive
c. hard drive
d. battery
6. Follow the procedure in After working inside your computer.
RF cable holder
Removing the RF holder
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
e. GPS board
f. WLAN card
g. docking board
3. To remove the RF holder:
a. Unroute the antenna cables from the cable routing clips [1].
b. Remove the screw that secures the RF holder to the computer [2] .
c. Lift and remove the RF holder from the computer [3] .
Installing the RF holder
1. Place the RF holder on the computer.
2. Install the screws that secure the RF holder to the computer.
3. Connect the antenna cables.
4. Route the antenna cables.
5. Install the:
a. docking board
b. WLAN card
35
To Next Page
Loading...
