a. system board
b. hard drive tray
c. WLAN card
d. WWAN card
e. GPS board
f. I/O board
g. optical drive
h. hard drive
i. base cover
j. battery
4. Follow the procedure in After working inside your computer.
Camera
Removing the camera
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. display assembly
3. To remove the camera:
a. Peel the adhesive tape [1] and disconnect the camera cable from the camera module [2].
b. Remove the screws that secure the camera to the display panel [3].
c. Peel the adhesive tape [4].
d. Lift the camera away from the display [5].
Installing the camera
1. Place the camera on the camera module.
2. Affix the adhesive tape to secure the camera module.
49
To Next Page
Loading...
